HSM SECURIO B24 Betriebsanleitung PDF herunterladen (Seite 16)

16 SECURIO B 24 11/2012

english

7 Cleaning and maintenance

WARNING

Dangerous mains voltage!

Switch off the shredder and pull

out the mains plug.

When cleaning only use a soft cloth and a

mild soap-water solution. However, no water

must enter the equipment.

Oil the cutting unit when

cutting performance de-

creases or the device

becomes noisy, or every

time you empty the waste

container (Cross cut only).

Only use HSM special

lubricating oil for the

cutting unit to do this:

• Spray the special cutting

unit oil through the paper feed along the

entire width of the cutting shafts.

• Let the cutting unit run in the permanent

mode for about 10 seconds without any

paper.

 Paper dust and particles are shaken off.

Note

Oiling the cutting unit also improves the cut-

ting performance of devices with strip cut.

8 Disposal / Recycling

Electrical and electronic old de-

vices contain a variety of valuable

materials, but also hazardous

substances which were required

for function and safety. Incorrect

disposal or handling can be dan-

gerous to your health and the environment.

Never dispose of old devices in the house-

hold waste. Observe the current applicable

regulations and use the collection points for

returning and recycling electric and elec-

tronic devices. Dispose of all the packaging

materials also in an environmentally-respon-

sible way.

Check that the container contact is work-

ing properly

WARNING

If the following procedure cannot

be performed, switch off the docu-

ment shredder, disconnect the

mains plug and contact customer service.

• Insert the mains plug and switch on the

shredder.

• Feed in a sheet of paper and tilt out the

container while the paper is being drawn in.

 The cutting unit must switch off immedi-

ately and the “container open” indicator

must light up.

• Insert the shredded material container

again fully.

 The cutting unit must not yet restart.

• Pull the paper out of the feed opening.

The light barrier must be clear.

• Switch off the machine and then switch

back on.



The cutting unit starts when paper is fed in.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 91 92

Kommentare zu diesen Handbüchern

Keine Kommentare